Preparing to Lay Turf

Prepare the ground by removing existing vegetation using , if necessary , herbicides and remove soil to remove roots, stones or lumps . Place the band around the perimeter which to place the lawn. Secure with nails or, in the case of a terrace or balcony , with double-sided tape . Should you require more than one roll of lawn, a series of operations are required to ensure that the joints are good.

Level the surface flattening the ground, until smooth and compact surface . From the starting point, the roll extend and flatten artificial turf possible folds of the coil. Paste grass on the side . To cut the grass roll should turn the roll and cut with a ruler black base.

Place a tissue permeable anti herbs as separation layer . For together , it is very important to verify that the fibres are in the same direction and the fit is perfect. To prevent falls and that the joints are perfect , lifting the edges of the lawn and proceed to binding tape it. Once cut , flip the r and check that the correct binding between the two , both at the beginning and end of the same .

Only in special situations where it is necessary to perfect drainage water , apply a layer of gravel over the fabric anti herbs. Wait 24 to ensure that it has been well established . Combing with a rake of the filaments opposite direction to lift the fringes. Both sides of the fold leaving about 70 cm wide and extending over the entire bonding surface of the bonding strip .

 Should you require silica, it is time to distribute the sand rake over the lawn in order to keep the raised fibres . Start at the end of the roll and the edges carefully with the centre of the connecting band . At the same time press the grass against the union side to ensure proper bonding .